Siemens HiPath 4000 - Manual (Page 23)

Putting the handset into service
15
Charging and using the batteries
To charge the batteries, insert the handset into the charging shell with the
keypad facing forwards.
The charging status is indicated by the charge status display. This flashes
during charging:
Battery operating and charging times
The operating times are only achieved after several charging and discharg-
ing cycles.
Attention:
Only use the relevant approved power supply units for operating
the charging shell (for order numbers see Æ page 94).
=
Batteries empty
e
Batteries 33% charged
V
Batteries 66% charged
U
Batteries 100% charged
Note:
• Initial charging: Charge the batteries for at least 5 hours with-
out a break, regardless of the charging status icon. Without
replacing it in the charging shell, use the handset until the "bat-
tery low" beep is heard. This action aligns the charge status dis-
play with the battery operating times.
• To attain full operating and charging times (Æ page 15): With-
out replacing it in the charging shell, use the handset until the
"battery low" beep is heard.
• For future charging: you can replace your handset in the charg-
ing shell each time it has been used. Charging is electronically
controlled, which ensures that the batteries are charged opti-
mally and with care.
Capacity (mAh) Stand-by mode
(hours)
Talk time
(hours)
Charging
time
(hours)
700
("Sanyo Twicell 650": 650)
approx. 150 (6 days) approx. 10 approx. 5 to
6