Siemens HiPath 4000 - Manual (Page 101)

Appendix
93
The handset is switched to data transfer mode by:
• activating read/write access to the phonebook
• activating read/write access to the e-mail directory
• activating read/write access to the call-by-call list
• activating read/write access to the appointments list
• activating read/write access to the redial list
• loading screensavers
• loading melodies
Cleaning the handset
Removing everyday dirt
To clean the handset and the charging shell, simply wipe them with a damp
or anti-static cloth. Never use a dry cloth.
Do not use abrasive cleaning agents.
After contact with liquids
1. Deactivate the handset immediately. Do NOT activate it!
2. Remove the batteries immediately. Leave the battery compartment
open.
3. Allow the liquid to drain off:
– Hold the handset in a horizontal position with the open battery com-
partment facing down.
– Hold the handset in a vertical position with the open battery compart-
ment facing down. Shake the handset gently, slightly tilting it back
and forth.
– Dab all components dry and then leave the handset in a warm spot
(other than a microwave, oven, etc...) for at least 72 hours with open
battery compartment and keypad facing down.
The handset can be put back into operation once it is completely dry.
Storage/Safekeeping
When storing your handset, take care to protect its soft parts from damage
by sharp objects. A protective case can help.
To order the protective case:
Mr. Sigmund Söllner
Tel.:+49 (89) 9221 6626
Fax: +49 (89) 9221 6599
E-mail: [email protected]
The handset automatically switches to idle if a fault occurs in the
course of transferring data.