Siemens HiPath 4000 - Manual (Page 22)

Putting the handset into service
14
Putting the handset into service
Removing the protective cover
Inserting the batteries
The handset is supplied with two approved batteries. The batteries are
supplied uncharged. They are charged in the handset.
Opening the battery compartment
Press down on the ridged surface and slide the cover from the battery
compartment.
Inserting the batteries
Insert the approved batteries making sure that the poles are facing the
right directions as indicated.
Closing the battery compartment
Put the cover back in place and slide it on to the battery compartment until
it engages.
Remove the protective cover from the display before
putting the handset into service.
Note:
• Note: Please observe the safety notes on the back cover.
• Only use approved batteries Æ page 16.
• Always replace both batteries at the same time and only use
two batteries of the same type/ from the same manufacturer!
• Open the battery compartment in a dust-free environment only.
• Your telephone directory entries and all settings remain stored
even if you remove the batteries. The date and time settings
will be reset.
• Only remove the batteries if they are defective. Any unneces-
sary removal of the batteries reduces their lifespan.