Samsung SMG-3200 - Manual (Page 178)

5-102
Chapter 5
CLI (Command Line Interface)
Onloopcheck frequency Onloopcheck frequency Onloopcheck frequency Onloopcheck frequency
Function In the Loop incoming mode, the Loop checks the disconnect tone periodically to
prevent the channel from being tied up.
For example, if the SMG-3200 system is in the tandem mode where VoIP enters
and then go out with seizing the Loop, the Loop may not be aware that the VoIP
part is disconnected, and thereby the Loop and SLC can be tied up. If you set this
function, the Loop checks the disconnect tone periodically to disconnect.
If you press [Enter] without entering the disconnected tone (in general, busy tone)
frequency, the system default frequency is set. 480Hz and 350Hz are available for
the frequency.
This CLI sets the currently active status, and if the setting needs to be maintained
during system booting, it must be saved in the CLI’s pstnmenu.
SMG-3200 frequency default value : 480Hz.
Procedure 1. At the SMG-3200 prompt, type 'Onloopcheck' and set the desired tone
frequency, and press [Enter]. 480Hz and 350Hz are available for the Tone
frequency.
SMG3200:165.213.81.230> Onloopcheck
On Loop Disconnect Check Function(480Hz)...
value = 46 = 0x2e = '.'
SMG3200:165.213.81.230>