Samsung SMG-3200 - Manual (Page 123)

5-47
3. Set values for the selected item referring to the following table, and press
[Enter].
No Item Description
0
Signal
Type
Selects H.323 signal type.
0. SlowStart : Q.931 ➔ H.245 ➔ Connection to Media
1. FastStart : Q.931 ➔ Connection to Media
1
Gateway
ID Sets the SMG-3200’s Gateway ID. If Caller ID Type is
GWID, it is the ID information that is sent to the other party.
2
Caller ID
Type
When sending a VoIP call via IP network, it selects the
Caller ID type that is sent from the SMG-3200 to recipients.
0. GWID: Uses Gateway ID number.
1. ANI: Uses Calling Numbers that are sent by PBX at
sender’s end.
2. IP: Uses IP address.
3. GWD+ANI: Uses Gateway ID number and Calling
Numbers that are sent by PBX at sender’s end.
4. Caller ID Table: Uses Caller ID in the Caller ID Table
3
Virtual
Ring Back
Tone
Sets whether to use virtual Ring Back Tone.
0. Disable: Do not use virtual Ring Back Tone.
1. Enable (Setup): uses virtual Ring Back Tone when
sending setup.
2. Enable (Alert): uses virtual Ring Back Tone when
receiving Alert.
4
DTMF
Signal
Type
Sets DTMP process method via IP network.
0. Inband: The DTMF signaling process through voice
channels.
1. H.245: The DTMF signaling process through H.245
signal method.
5
FAX
Signal
Type
Internet fax is processed in the real-time event relay method.
It sets a protocol for it.
0. T.38 : Uses standard T.38 fax protocol.
1. Samsung : Uses Samsung own protocol.
6
H.245
Open in
FastStart At the time of Fast Start, specifies (in terms of Yes/No) if
H.245 channel is to be opened using H.245 channel
information in setup information.