IBM 1800409-001A - Manual (Page 405)

Updated PCL 5 DOCs
%%IncludeFeature:scalablefonts(value)
Purpose: Enables/disables PCL 5 scalable fonts (to print PCL 4
documents that have selected PCL 5 scalable fonts or
to more closely emulate the PCL 4 font environment).
value: 0 (enables scalable fonts) or 1 (disables scalable fonts)
Default: 0
%%IncludeFeature:install(resource id object id)
Purpose: Establishes the current resource and the default object
ID value for the current job to which it is attached. If it
is attached to a job that downloads a font without
setting the current object ID using the PCL escape
sequence (#X, it has the appearance of
“ sto rin g” th e f on t o n d isk. If no
%%IncludeFeature:install DOC command is sent, the
internal default location is used; otherwise, this
parameter, which must be provided, specifies one of
the alternate locations. For most QMS printers,
resource 6 is the internal system disk.
resource id: 0 to 6 (identifies one of the possible locations for
downloaded objects). Default: internal system disk
object id: 0-32767 (assigns an ID to an object, such as a font,
macro, or pattern). Default: 0. The object ID can be
used instead of the usual PCL command to assign an
ID. This ID is overwritten by any ID assigned from the
PCL print job, if present. If neither a DOC command
nor the PCL print job specify an ID, the default ID of
0 is used. Identifiers must be unique. If the ID matches
an ID for an existing object, that object is deleted and
r ep l ac ed b y t h e n ew o b je ct . If a
%%IncludeFeature:remove command precedes a
%%IncludeFeature:install command, the install
command is ignored (these two commands are
mutually exclusive). All downloaded objects are by
default temporary and will be deleted at the end of a
Appendix D
A d d i t i o n a l T e c h n i c a l I n f o r m a t i o n D - 1 7