IBM 1800409-001A - Manual (Page 312)

14. Press the Select key to enter the communication port submenu.
The following appears on the second line of the message
window:
TARGET DISK 6
15. Press the Select key. The following message appears in the
window:
INSTALL TO DISK
CONNECTING....
16. At your PC, at the C:\QMSSYS prompt, send the files you just
extracted to the parallel port using the DOS copy command
with the /b (binary file) option:
copy /b *.dl lpt1:
↵
The software is installed when the following message
appears:
INSTALL TO DISK
COMPLETE
Once you have completed installing the system software, you
are ready to restart the system as described here:
17. Press the Menu key. The message window displays the
following message:
QMS SOFTLOAD x.x
INSTALL TO DISK
18. Press the Next key until the message window displays the
following message:
QMS SOFTLOAD x.x
BOOT SYSTEM
19. Press the Select key to enter the Boot System submenu. The
following message appears in the message window:
Chapter 8
8 - 5 6 P r i n t e r O p t i o n s