Icom IC-2800H - Manual (Page 50)

46
9
SCAN OPERATION
■ Skip channel setting
Memory channels can be set to be skipped for memory skip
scan. In addition, memory channels can be set to be skipped
for both memory skip scan and full/band/programmed scan
(frequency skip scan). This is useful to speedup the scan in-
terval.
q Select a memory channel you wish to set skip information.
w Push the desired band’s [ (MAIN) EDIT] for 2 sec. to enter the
edit screen.
• Push [CHG/L] if [(MAIN) EDIT] is not displayed.
e Push [SKIP] to select the condition.
• “ ≈ ” for memory skip scan.
• “P ≈ ” for frequency skip scan and memory skip scan.
• No “ ≈ ” or “P ≈ ” indication for no skipping of channels.
r If you want to set other channels, rotate the right-hand tun-
ing dial. Repeat
e to set the desired condition.
• Push [CH] if memory channel does not flash.
t Push [ ï ] to exit the edit screen.
■ Scan resume condition
The scan resume condition can be selected as a pause or
timer scan for each band. When receiving signals, the scan
pauses according to the scan resume condition.
q Push the desired band’s [ (M/C) SCN] for 2 sec. to enter scan
screen.
• Push [CHG/L] if [(M/C) SCN] is not displayed.
w Push [ (SEL) Res] one or more times for 2 sec. to select con-
dition.
• “5s” : scan pauses for 5 sec. on a received signal.
• “10s” : scan pauses for 10 sec. on a received signal.
• “15s” : scan pauses for 15 sec. on a received signal.
• “Pause” : scan pauses on a received signal until it disappears.
e Push [ (MAIN) í ] for 2 sec. to exit scan screen.
ï
Y
Z
CH
SKIP
MW
MEMORY E D I T
( T S=1 2 . 5 k)
Name ICOM2800
R - Tone
C - Tone
OW 1 2 3 . 0
8 8 . 5
0.600 0
145.320
12
P Skip channel
information
M - L
SCAN
P1 1 4 4 . 2 - 1 4 5 . 8
Resume 15s
145.320
12
MAIN
43
3.000
12
í
MAIN
PRIO
PRO
TON
Res
SEL
SCP
MAIN
TS
V/M H
SCN
M/C
LOW
MONI
M I D - L O
15 sec. resume time