Icom IC-2800H - Manual (Page 24)

20
4
FREQUENCY SETTING
■ Using the tuning dial
q Select VFO mode with the desired band’s [V/M H ].
• Push [CHG/L] if [V/M H ] is not displayed.
w Rotate desired band’s [DIAL] to change the frequency.
• The frequency changes according to the selected tuning steps.
See the next page for selecting the tuning step.
D 1 MHz tuning step
Push the selected band’s [V/M H ] to select 1 MHz tuning step.
Push [V/M H ] again to return to the previous tuning step.
D 10 MHz and 1 MHz tuning steps
Push the selected band’s [V/M H ] once or twice to select 10
MHz or 1 MHz tuning step, respectively. Push [V/M H ] once or
twice to return to the previous tuning step.
Some versions do not have the 10 MHz tuning step.
■ Using the [ Y ]/[ Z ] keys
q Push [BAND] to select the desired band.
w Push [VFO] to select the VFO mode.
e Push [ Y ] or [ Z ] to select the desired frequency.
• The frequency changes according to the selected
tuning steps. (p. 21)
• Pushing [ Y ] or [ Z ] for more than 0.5 sec. activates
a scan. If this happens, push [ Y ] or [ Z ] again to
cancel the scan.
1 MHz or 10 MHz steps cannot be used via the [ Y ]/[ Z ]
keys.
MAIN
SCP
MAIN
SCP
V/M H
TS
V/M H
TS
MAIN
12
14
5.___
MAIN
SCP
MAIN
SCP
V/M H
TS
V/M H
TS
MAIN
12
14
_.___
While 1 MHz tuning step is
selected, the digits below
100 kHz disappear.
While 10 MHz tuning step is
selected, the digits below
1 MHz disappear.
Y Z