Icom IC-2800H - Manual (Page 25)

■ Setting a tuning step
Tuning steps can be selected for each band. This transceiver
has 8 tuning steps as follows:
• 5 kHz
• 10 kHz • 12.5 kHz • 15 kHz • 20 kHz
• 25 kHz • 30 kHz • 50 kHz
q Select VFO mode with the desired band’s [V/M H ].
• Push [CHG/L] if [V/M H ] is not displayed.
w Push [ (V/M H ) TS] for 2 sec. to enter tuning step screen.
e Rotate desired band’s [DIAL] to select the desired tuning
step.
• Pushing [5], [20] or [25] also selects 5, 20 or 25 kHz tuning step.
r Push [ í ] to return to normal operation.
21
4
FREQUENCY SETTING
MAIN
43
3.000
14
5.000
12
í
5
20
25
SCP
MAIN
TS
V/M H
SCN
M/C
LOW
MONI
TS = 5.0k TS = 5.0k
Return to previous menu
Shows 5 kHz tuning step is selected.
Select 5 kHz tuning step
Select 20 kHz tuning step
Select 25 kHz tuning step
• Cloning mode information
The information in the transceiver, such as memory chan-
nels, memory names, etc. can be programmed using a PC.
The transceiver displays the following information when the
transceiver enters cloning mode for programming.
In the cloning mode, the [POWER] switch does not func-
tion. Push the [UP]/[DN] or [
Y ]/[ Z ] on the microphone to
return to the normal operating condition.
Push mic UP/DN to EXIT.
CLONE