Icom IC-2800H - Manual (Page 49)

45
9
SCAN OPERATION
■ Memory scan
q Select memory mode with the desired band’s [M/C].
• Push [CHG/L] if [M/C] is not displayed.
• “
! ” appears when memory mode is selected.
w Make sure the squelch is set to the threshold point.
e Push [ (M/C) SCN] for 2 sec. to enter the scan screen.
• If the pocket beep function is activated, the transceiver automat-
ically selects the tone squelch function when the scan screen is
selected.
r Push [MEM] momentarily to start the scan.
• Decimal point and “ ! ” flash while scanning.
• To change the scanning direction, rotate the desired band’s tun-
ing dial.
t To stop the scan, push [MEM] again.
y Push [ (MAIN) í ] for 2 sec. to exit the scan screen.
q Select the desired band with [BAND].
w Select memory mode with [MR].
e Push [SQL Y ] or [SQL Z ] to set the squelch to
the threshold point.
r Push [ w SCAN] momentarily or [ Y ]/[ Z ] for 2
sec. to start memory scan.
• Decimal point and “ ! ” flash while scanning.
t Push [ Y ], [ Z ] or [ E CLR] to cancel the scan.
At least 2 memory channels must be programmed for
memory scan to start.
Y Z
M - L
SCAN
1 4 4 . 0 - 1 4 6 . 0
Resume 15s
145.320
12
MAIN
43
3.000
12
í
MAIN
PRIO
MEM
TON
Res
SEL
SCP
MAIN
TS
V/M H
SCN
M/C
LOW
MONI
M I D - L O
M