Icom IC-2800H - Manual (Page 42)

38
7
MEMORY/CALL CHANNELS
■ Call channel
1 call channel is available for each band to store a most-often-
used frequency for quick recall.
D Selecting a call channel
q Push [M/C] to select a call chan-
nel.
• Push [CHG/L] if [M/C] is not dis-
played.
• “C” appears when call channel is
selected.
w Push [V/M H ] to select VFO mode, if desired.
q Select the desired band with [BAND].
w Push [ (MR) CALL] for 2 sec. to select the se-
lected band’s call channel.
D Programming a call channel
q Select VFO mode with the desired band’s [V/M H ].
• Push [CHG/L] if [V/M H ] is not displayed.
w Set the desired frequency:
➥ Set the frequency using the desired band’s tuning dial.
➥ Set other data (e.g. offset frequency, duplex direction,
subaudible tone frequency, etc.), if required.
e Push the desired band’s [S.MW] momentarily to indicate
memory channels.
• Push [CHG/L] if [S.MW] is not displayed.
• Do not hold [S.MW] for more than 0.5 sec., otherwise the mem-
ory channel will overwrite the selected memory channel.
r Rotate the tuning dial to select the call channel.
• “C” appears when a call channel is selected.
t Push [ (S.MW) MW] for 2 sec. to program.
M I D - L O C
MAIN
SCP
MAIN
TS
V/M H
SCP
MAIN
TS
V/M H
14
6.010
MAIN
1
14
6.200
M I D - L O
MAIN
EDIT EDIT
MAIN
TON
DUP
TON
DUP
MAIN
1
14
6.200
M I D - L O
MAIN
EDIT EDIT
MAIN
TON
DUP
TON
DUP
MAIN
1
14
6.010
14
6.010
M I D - L O M
MAIN
EDIT EDIT
MAIN
TON
DUP
TON
DUP
MAIN
M I D - L O M
MAIN
EDIT EDIT
MAIN
TON
DUP
TON
DUP
S.MW
MW
S.MW
MW
C
momentarily
call channel
for 2 sec.
[EXAMPLE]: Programming a call channel.
CALL