Icom IC-2800H - Manual (Page 43)

39
7
MEMORY/CALL CHANNELS
D Programming a call channel via the
microphone
The HM-98 microphone can also be used to pro-
gram a call channel.
q Select the desired band with [BAND].
w Select VFO mode with [VFO].
e Set the desired frequency.
• Set other data (e.g. offset frequency, duplex direction, subaudible
tone frequency, etc.), if required.
r Push [FUNC] then [ E MW] momentarily to indicate mem-
ory channels.
• Do not hold [MW] for more than 0.5 sec., otherwise the memory
channel will overwrite the selected memory channel.
t Push [ Y ] or [ Z ] to select the call channel.
• “C” appears when the call channel is selected.
y Push [FUNC] then [ E MW] for 2 sec. to program.
D Transferring call channel contents
The call channels can be transferred in a similar manner to
memory channel transferring.
q Select call channel with the desired band’s [M/C].
• Push [CHG/L] if [M/C] is not displayed.
• “C” appears when the call channel is selected.
w Push [ (S.MW) MW] for 2 sec. to transfer.
• Push [CHG/L] if [S.MW] is not displayed.
D Transferring call channel contents via the
microphone
q Select the desired band with [BAND].
w Push [ (MR) CALL] for 2 sec. to select the desired band’s call
channel.
• “C” appears when the call channel is selected.
e Push [FUNC] then [ E MW] for 2 sec. to transfer.
MW
A