Multi-Tech Systems MMCModem GPRS (MTMMC-G) - Manual (Page 97)

Chapter 11 – Data Commands
Multi-Tech Systems, Inc. Wireless GSM/GPRS AT Commands (Document Number S000293I) 97
Select Data Compression %C
Description: This command enables or disables data compression negotiation if this feature is supported on the
product.
Values:
0 no compression (default)
2 V42bis compression if supported
Syntax: Command syntax: AT%C
Command Possible responses
AT%C0
Note: Command OK
Note: Feature supported
AT%C2
Note: Command OK
Note: V42bis supported
AT%C?
Note: Current value 2
OK
Note: Command valid
V42bis Data Compression +DS
Description: This command enables or disables V.42bis data compression if this feature is supported on the product.
Note that the product allows only the MNP2 protocol.
Values: < dir > Specifies the desired direction(s) of operation of the data compression function; from the
DTE point of view, (default is 3)
0 Negotiated … no compression
1 Transmit only
2 Receive only
3 Both directions, accept any direction. Default.
< neg > Specifies whether or not the DCE should continue to operate if the desired result is not
obtained, (default is 0)
0 Do not disconnect if V.42 bis is not negotiated by the remote DCE as specified in
Default.
1 Disconnect if V.42 bis is not negotiated by the remote DCE as specified in
< P1 > Specifies the maximum number of dictionary entries that should be negotiated,
Range is 512 to 2048. Default is 2048.
< P2 > Specifies the maximum string length to be negotiated. Range is 6 to 250. Default is 20.
Syntax: Command syntax: AT+DS=[[
Command Possible responses
AT+DS=?
Note: Test command +DS: (0-3),(0,1),(512-2048),(6-250)
OK
AT+DS=3,0,2048,250
Note: Set new parameters OK
Note: Command valid
AT+DS?
Note: Current values +DS: 3,0,2048,20
OK
Note: Command valid