Chapter 6 – network service commands, Signal quality +csq, Operator selection +cops – Multi-Tech Systems MMCModem GPRS (MTMMC-G) User Manual
Page 31

Chapter 6 – Network Service Commands
Multi-Tech Systems, Inc. Wireless GSM/GPRS AT Commands (Document Number S000293I)
31
Chapter 6 – Network Service
Commands
Signal Quality +CSQ
Description:
This command determines the received signal strength indication (
(
Values:
0
-113 dBm or less
1
-111 dBm
2 to 30 -109 to –53 dBm
31
-51dBm or greater
99
not known or not detectable
0…7:
as RXQUAL values in the table GSM 05.08
99
not known or not detectable
Syntax:
AT+CSQ
Command Possible responses
AT+CSQ
+CSQ:
OK
(Note:
Operator Selection +COPS
Description:
There are three possible ways of selecting a Public Land Mobile Network (PLMN) operator:
•
The product is in
manual mode. It then tries to find the operator specified by the application
and if found, tries to register.
•
The product is in
automatic mode. It then tries to find the home operator and if found, tries to
register. If not found, the product automatically searches for another network.
•
The product enters into
manual/automatic mode, and then tries to find an operator as
specified by the application (as in manual mode). If this attempt fails, it enters
automatic
mode. If this is successful, the operator specified by the application is selected. The mobile
equipment then enters into
automatic mode.
Note:
The read command returns the current mode and the currently selected operator. In manual
mode, this PLMN may not be the one set by the application (as it is in the search phase).
These commands are not allowed during communication.
Values:
0
automatic (
default value)
1
manual
2
deregistration; ME will be unregistered until
3
set only
4
manual / automatic (
entered.
0
long alphanumeric format
1
short alphanumeric format
2
numeric
0
unknown
1
available
2
current
3
forbidden