Motorola ENTERPRISE DIGITAL ASSISTANT MC70 - Manual (Page 169)

Maintenance and Troubleshooting 8 - 5
Can’t make my
Ericsson R520
phone discoverable. You attempted to bond
with the phone, and
when the phone
presented a “pairing
query,” you entered No.
This prevents the phone
from being discoverable
until it is reset. Reset the phone by removing its battery.
There is a delay in
the Bluetooth stack
re-initializing during
a resume from
suspend. This is normal behavior. No solution required.
Piconet (the
connection between
a Bluetooth master
and one or more
Bluetooth slaves)
drops. The EDA suspends and
the Bluetooth radio
power turns off.
One of the devices are
out of range.
An application can register for notification of an EDA
resume by creating a message queue using the
CreateMsgQueue() API and power notifications using the
RequestPowerNotifications() API (refer to the SMDK Help
File). After an application receives a resume notification it
should close open Bluetooth sessions and reopen
them.This reestablishes the piconet lost during the
suspend.
My application
created a
successful
RFCOMM session
with another
Bluetooth device
but the session was
dropped. Device went out of range
or was shut off. Check the return value of APIs for errors. Look for a DCD
state change event in the Microsoft Bluetooth stack DCD
window of the Bluetooth connection.
After completing an
RFCOMM session
with another
Bluetooth device, I
was unable to
create a virtual
COM port to
connect to another
Bluetooth device. The Microsoft Bluetooth
stack holds a baseband
connection for ten
seconds after an
application closes its
session and exits. This
was designed to allow for
speedy connections to
the same device if other
profiles were to connect. Either wait 10 seconds, choose a different COM port
number for the virtual COM port, or modify
HKLM\software\Microsoft\bluetooth\l2cap\IdlePhys (which
defines the number of seconds to hold the connection).
Table 8-2 Troubleshooting Bluetooth Connection (Continued)
Problem Cause Solution