MITSUBISHI ELECTRIC QJ71C24N - Manual (Page 51)

3 - 1 3 - 1
MELSEC-Q
3 SPECIFICATIONS
3
3 SPECIFICATIONS
The following shows the Q series C24 performance specifications.
See the User's Manual of the QCPU (Q mode) for general specifications.
3.1 Performance Specifications
The following shows the Q series C24 performance specifications. For the
transmission specifications when communicating via the modem function, see this
section and Chapter 3 of User's Manual (Application).
(1) Transmission specification
Specifications
Item QJ71C24N
QJ71C24
QJ71C24N-R2
QJ71C24-R2
QJ71C24N-R4
CH1
RS-232-compliance
(D-sub 9 pin)
RS-232-compliance
(D-sub 9 pin)
RS-422/485-compliance
(2-piece plug-in connector socket
block)
Interface
CH2
RS-422/485-compliance
(2-piece terminal block)
RS-232-compliance
(D-sub 9 pin)
RS-422/485-compliance
(2-piece plug-in connector socket
block)
Line Full-duplex/half-duplex communications
MC protocols
communication
Half-duplex communications
Non procedure protocol
communication
Full-duplex/full-duplex communications
Communications
system ( 1)
Bidirectional protocol
communication
Full-duplex/full-duplex communications
Synchronization method Start-stop synchronization method
[QJ71C24N(-R2/R4)]
50 300 600 1200 2400 4800 9600
14400 19200 28800 38400 57600 115200 230400 (bps)
• Transmission speed 230400 bps is available for only CH1. (Not available for CH2)
• Total transmission speed of two interfaces is available up to 230400 bps.
•
Total transmission speed of two interfaces is available up to 115200 bps when the communication data
monitoring function is used.
[QJ71C24(-R2)]
50 300 600 1200 2400 4800 9600
14400 19200 28800 38400 57600 115200 - (bps)
Transmission speed
• Total transmission speed of two interfaces is available up to 115200 bps.
Start bits 1
Data bits 7/8
Parity bits 1 (vertical parity) or none
Data format
Stop bits 1/2
MC protocol communication
Processes one request during installed PLC CPU END processing.
Number of scans that must be processed/number of link scans depends on the contents of the request.
(See Reference Manual.)
Access cycle Non procedure protocol
communication
Bidirectional protocol
communication
Sends each time a send request is issued. Can receive at any time.
Parity check All protocols and when ODD/EVEN is selected by parameter.
Error detection
Sum check code
MC protocol/bidirectional protocol selected by parameter.
Non procedure protocol selected by user frame.
(Continued on next page)