MITSUBISHI ELECTRIC Mitsubish Q Series QJ71E71-100 - Manual

Series HMI Connection Manual
134
V1.01 Revision November, 2011
Mitsubishi Q Series Ethernet
（
Supports QJ71E71 / QJ71E71-B2 / QJ71E71-B5 / QJ71E71-100 Series Module）
HMI Factory Setting:
Baud rate: 192.168.0.1
Controller Station Number: 1025
Control Area / Status Area: D0 / D10
Connection
Standard jumper Cable/ Network Cable without jumper (Auto-detected by HMI)
Definition of PLC Read/Write Address
a. Registers
Format
Type
Word No. (n)
Read/Write Range Data Length Note
Input Xn X0 – X1FF0 Word Hexadecimal,
2
Output Yn Y0 – Y1FF0 Word Hexadecimal,
2
Internal Relay Mn M0 – M8176 Word 2
Special Internal Relay Mn M9000 – M9240 Word 3
Link Relay Bn B0 – B1FF0 Word Hexadecimal,
2
Annunciator Fn F0 – F2032 Word 2
Timer Value TNn TN0 – TN2047 Word
Counter Value CNn CN0 – CN2047 Word
Data Register Dn D0 – D8191 Word
Special Data Register Dn D9000 – D9255 Word
Link Register Wn W0 – W1FFF Word Hexadecimal
b. Contacts
Format
Type
Bit No. (b)
Read/Write Range Note
Input Xb X0 – X1FFF Hexadecimal