MITSUBISHI ELECTRIC QJ71C24N - Manual (Page 181)

8 - 2 8 - 2
MELSEC-Q
8 UTILITY PACKAGE (GX Configurator-SC)
8
8.1 Functions Available with Utility Package
The following table lists the utility package function.
( : indicates that the setting is valid with the applicable protocol.)
Function MC
Non
procedure
protocol
Bidirectional
protocol
Explanation
page
Remarks
Auto refresh setting
Refresh the Q series C24's error codes and set devices on the PLC
CPU side.
Section 4.6
User frame Register the user frame in the flash ROM. — Section 8.4.1
Data for modem initialization Register the data for modem initialization in the flash ROM. Section 8.4.2
Data for modem connection Register the data for model connection in the flash ROM. Section 8.4.3
Modem function system
setting
Register the system setting values for model function in the flash
ROM.
Section 8.4.4
CHn Transmission
control and others
system setting
Set the transmission specifications with the other device.
(DTR/DSR control, DC code control, communication method, data
communication monitoring timer value, etc.)
Section 8.4.5
CHn MC protocol
system setting
Assign the buffer memory for on-demand function, set the user
frame number, etc.
— — Section 8.4.6
CHn Non procedure
system setting
Assign the buffer memory needed to perform data communication
using the non procedure protocol, and change the setting values,
etc.
— — Section 8.4.7
CHn Bidirectional
system setting
Assign the buffer memory needed to perform data communication
using the bidirectional protocol, and change the setting values, etc.
— — Section 8.4.8
CHn PLC CPU
monitoring system
setting
Set the PLC CPU monitoring function. — Section 8.4.9
System
setting
CHn Transmission
user frame No.
designation system
setting
Set the user frame number to be transmitted, etc. — — Section 8.4.10
Can be used
via online
operation.
Can be used
via offline
operation.
System setting default
Reset the setting values in the buffer memory to their default
values.
Section 8.4.11
System setting write Write the setting values in the buffer memory to the flash ROM. Section 8.4.11
Flash ROM write
allow/prohibit designation
Set whether to allow or prohibit writing to the flash ROM. — — — Section 8.4.12
X · Y monitor/test Perform the monitoring/testing of I/O signals to/from the PLC CPU. Section 8.6.1
Modem function monitor/test Monitor the execution status of the modem function. Section 8.6.2
CHn Transmission
control and others
monitor/test
Monitor the status of interface control signals, values set from the
GX Developer, etc.
Section 8.6.3
CHn MC protocol
monitor
— — Section 8.6.4
CHn Non procedure
monitor/test
— — Section 8.6.5
CHn Bidirectional
monitor
Monitor the data communication result, I/O signal status, and
setting values in the buffer memory.
— — Section 8.6.6
CHn PLC CPU
monitoring monitor
Monitor the setting values and operating status of the PLC CPU
monitoring function.
— Section 8.6.7
Monitor
CHn User frame
No. designation
monitor for
transmission
Monitor the setting value for user frame to be transmitted. — Section8.6.8
Monitor/test others Monitor the data reception result, error occurrence status, etc. Section 8.6.9
ERR LED off Turn off the ERR LEDs on the front face of the module. Section 8.6.10
Non procedure protocol
receive data clear
Clear the currently received data. — — Section 8.7
Can be used
only via
online
operation.