Appendix 9.10 when reading user frame, Melsec-q, Appendix appendix 9.10 when reading user frame – MITSUBISHI ELECTRIC QJ71C24N User Manual
Page 344: Point, 1) program conditions
App. - 50 App. - 50
MELSEC-Q
APPENDIX
Appendix 9.10 When reading user frame
The following program example reads a user frame registered to the flash ROM of the
Q series C24 using the REMFR/REMTO instruction and I/O signals.
Refer to Section 9.4 of the User's Manual (Application) for details.
POINT
It is recommended to use GX Configurator-SC when reading a user frame
registered to the flash ROM of the Q series C24. (Refer to Chapter 8.)
(1) Program conditions
The following program reads a user frame registered to the flash ROM of the
QJ71C24N when the read command (X1029) turns ON.
(a) Devices used
:
• Read command....................................................................... X1029
• Read command pulse signal .................................................. M10
• Read flag ................................................................................. M11
• Registration result acquisition command ............................... M12
• Number of data byte registered acquisition command.......... M13
• User frame acquisition command........................................... M14
• Completion device for REMFR/REMTO instruction .............. M100 to 107
• Normal/abnormal completion flag for REMFR/REMTO
instruction................................................................................ M200 to 204
• Read instruction ...................................................................... D0
• Frame No. ............................................................................... D1
• Read result .............................................................................. D2
• Number of data bytes registered ............................................ D3
• User frame .............................................................................. D4 or later
• Number of registered data...................................................... D50, D100
(b) Buffer memory settings used in this example
These settings are used to read the user frame registered in Appendix 9.9.
Address Decimal (Hexadecimal)
CH1
Name
Setting
value
2 (2
H
)
Register/read/delete instructions
2
3 (3
H
)
Frame No. direction
03E8
H
4 (4
H
)
Registration/read/delete result storage
—
5 (5
H
)
Number of data bytes registered designation
10
6 (6
H
)
3946
H
7 (7
H
)
3030
H
8 (8
H
)
3030
H
9 (9
H
)
4646
H
10 (A
H
)
For flash ROM
access
User frame
3030
H