FUJITSU DESKPOWER 5000 - Manual (Page 78)

68
Even if passwords are set by the BIOS setup utility, they are not rendered effective until the
jumper switches are changed.
Help
If the password necessary to boot the BIOS setup system is not known, return JP5 to 2-
3. The password check is disabled.
● Starting the computer after password setup
After 'Set User Password' is set, the personal computer displays a password entry window
when turned on again or the user attempts to run the BIOS setup utility.
Enter a password and press the Enter key.
Front
JP5 jumper
switch 1-2........Enables a
password.
2-3........Disables a
password.
1
2
3
13
After 'Set Supervisor Password' is set, the computer displays a password entry window when
the user attempts to run the BIOS setup utility. Enter a password and press the Enter key.
Point
If the user enters an incorrect password three times, the system stops, in which case the
Power switch must be pressed to turn the system off. After waiting at least ten seconds, turn
the system on again and enter the correct password.
Enter Password.
? ? ?
Enter Password.
10-Chap4(63-82) 25/4/00, 10:37 am 68