FUJITSU DESKPOWER 5000 - Manual (Page 50)

40
9
Connect the flat cable.
Connect the flat cable that is appropriate for
the internal option to be installed.
- To install two IDE-standard internal options
to the IDE secondary cable (if one of the
options is a hard disk), install the hard disk
at the master side.
- To install a SCSI interface internal option:
Connect the flat cable to the SCSI card in
the expansion slot.
- To install a floppy disk drive:
Connect the flat cable to the expansion card
of the internal floppy disk drive in the
expansion slot.
10
Connect the power cord.
Connect the unused power cord to the
connector of the installed internal option.
Connected to the riser board
Connected when set to the slave
Connected when set to the master
SLAVE MASTER
Blue or red line
Pin 1
08-Chap3(34-44) 25/4/00, 10:36 am 40