FUJITSU DESKPOWER 5000 - Manual (Page 40)

30
Starting and terminating the ICU (For a PC using Windows NT)
○ ○ ○ ○ ○ ○ ○
This section explains how to start and terminate the ICU using Windows NT.
1
If the PC is turned on, turn it off.
2
Confirm that the "boot disk" is in write-enable status, insert in the floppy disk drive,
then turn on the PC.
MS-DOS is started.
3
Confirm that the "Plug and Play kit for MS-DOS(R) ICU R1.21 disk 1" is in write-enable
status, replace the disk with the "boot disk", then enter the following character string
and press the [Enter] key:
The ICU is started.
Point
- Do not remove the "Plug and Play kit for MS-DOS(R) ICU R1.21 disk 1" from the floppy disk
drive when using the ICU.
- Use the keyboard for all ICU operations.
- Do not set the PCI devices to "Disabled" with the ICU. The devices may not be reset to
"Enabled."
4
Set up the resources.
When resource setup is terminated, terminate the ICU.
5
Press [Alt]+[F].
The pull-down menu appears.
6
Select the "Exit" command and press the [Enter] key.
7
Turn off the PC main unit.
icu
08-Chap3(20-33) 25/4/00, 10:36 am 30