FUJITSU DESKPOWER 5000 - Manual (Page 68)

58
● Internal Devices Configurations Setting
This submenu is used to set up built-in devices.
Move the cursor to this item and press the Enter key to display a submenu as shown below.
– Floppy Disk Controller
This item sets whether the floppy disk controller is enabled.
- Disabled
The floppy disk controller is disabled and resources are freed.
- Enabled (Initial value)
The floppy disk controller is enabled.
– IDE Controller
This item sets whether the IDE interface is enabled.
- Disabled
The IDE interface is disabled and resources are freed. All devices connected to the IDE
interface are disabled.
- Primary
The primary IDE interface is enabled. The resources of the secondary ID interface are
freed and all devices connected to the secondary IDE interface are disabled.
- Both (Initial value)
Both the primary/secondary IDE interfaces are enabled.
– Sound Controller
This item sets whether the built-in sound bus is enabled.
- Disabled
The built-in sound bus is disabled and resources are freed.
- Enabled (Initial value)
The built-in sound bus is enabled.
F1 Help
↑↓
Select Item -/Space Change Value F9 Setup Defaults
ESC Exit
←→
Select Menu Enter Select : Sub-Menu F10 Save and Exit
PhoenixBIOS Setup Utility
Main Advanced Security Power Boot Info Exit
Internal Devices Configurations
Floppy Disk controller: [ Enabled ]
IDE Controller: [Both]
Sound Controller: [Enabled]
LAN Controller: [Enabled]
USB Peripherals: [Enabled]
Item Specific Help
[Enables]
Floppy Disk drives
are enabled.
[Disabled]
Floppy Disk drives
are disabled. The
IRQ6 may be
released.
10-Chap4(46-62) 25/4/00, 10:37 am 58