FUJITSU DESKPOWER 5000 - Manual (Page 119)

109
Appendix
Windows NT4.0 model
1
Turn off the power, then replace the display.
2
Start the PC with Windows NT Workstation Version 4.00 [VGA mode].
3
Set the resolution, the number of colors, and the refresh rate in accordance with the
display specifications, then restart the PC.
Display and power save mode
○ ○ ○ ○ ○ ○ ○
Windows 95 model
When a display that does not support the power save mode is used, select "Detailed
Properties od Display" from "Screen Properties," then select the "Monitor" tab and turn off the
checkbox of "Power Save Display."
Windows 98 model
When a display that does not support the power save mode is used, open to "Power
Management Properties" and set "Never" for both "System Standby" and "Turn off Monitor
Power."
Windows 2000 model
When a display that does not support the power save mode is used,open to "Power Options
Properties" and set "Never" for both "System Standby" and "Turn off monotor".
About USB (Windows 95/98/2000)
○ ○ ○ ○ ○ ○ ○
USB stands for Universal Serisl Bus, which standardizes mouse. keyboard,
printer, modem, and speaker interfaces.
Point
• Some types of peripheral devices that support USB require special device drivers to be
installed.
• The OSs that support USB are Windows 95/98/2000. However, in Windows 95 mode, USB
devices must be compatible with Windows 95.
• When USB equipment is connected, Windows may not be terminated normally depending on
the type od USB equipment. If this is the case, disconnect the USB equipment and terminate
Windows.
14-APPENDIX(92-110) 25/4/00, 10:37 am 109