Registering the track name, Model d2424 reference manual (editing tracks), Flashing – Fostex D2424 User Manual
Page 74
Model D2424 Reference Manual (Editing Tracks)
74
∞
42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
24
∞
42
OL
0
30
24
18
12
9
6
3
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
CLOCK
INT
∞
42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
PGM
24
∞
42
OL
0
30
24
18
12
9
6
3
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
CLOCK
INT
∞
42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
PGM
24
∞
42
OL
0
30
24
18
12
9
6
3
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
CLOCK
INT
Any type of track name can be registered or edited for each real track/additional track.
In general, after the current drive is formatted, a "
Temporary title
"("#TRACK 1," etc.) is automati-
cally registered for all tracks.
This temporary title can be changed and registered as you wish using the "
Track Name Edit?
" menu
in the SETUP mode.
For example, to allow checking at a glance, sound sources (guitar, keyboard, vocal...etc.) recorded
on each track, a maximum 8 digit track name can be registered, such as "Guitar" for track 1,
"Keyboard" for track 2, "Vocal" for track 3, and so on.
Registering the Track name
1. Enter the SETUP mode while in the stop mode by
pressing the [SETUP] key.
2. Select the "Track Name Edit?" display by rotating
the [JOG] dial, and then press the [EXECUTE/YES]
key.
As shown below, the display will change to selecting
the desired track and the track number will flash.
In the example below, "
01
" in "
TRK:01
" will flash.
3. Rotate the [JOG] dial while "01" is flashing to
select the desired track number, and press the
[EXECUTE/YES] key.
The flashing number will move to the left-end digit to
allow input of new letters and symbols (In example
below, "
#
" will flash).
4. Numbers and symbols can be input at the selected
(flashing) digit by rotating the [JOG] dial, and the
flashing digit can be moved with the [SHUTTLE]
dial.
If the [
JOG
] dial is rotated at the edit point, letters/
numbers/symbols listed in the following can be input.
A maximum of 8 digits can be input for a name.
5. After input of the desired track name, press the
[EXECUTE/YES] key.
By pressing the [
EXECUTE/YES
] key, the D2424 will
change to the track number selecting display, the same
as in Step-2 (Track number will flash).
6. If you wish to continue registering track names,
repeat
7. Upon completing registering of the track names,
press the [EXIT/NO] key to exit from the SETUP
mode.
Flashing
Flashing