Manual punch in/out, Preparation, Rehearsing manual punch in/out – Fostex D2424 User Manual
Page 42: Cancelling rehearsal mode, Rehearsing manual punch in/out recording
42
Model D2424 Reference Manual (Punch In/Out)
Press the foot switch at the
Punch In point.
Track 5
Track 6
Track 7
Track 8
Auto Punch In point
(Take In)
Track 1
Track 2
Track 3
Track 4
This part is changed.
Start point of
playback
Auto Punch Out point
(Take Out)
End point of
playback
All tracks are in
playback monitoring
mode.
Only track 3 in input
monitoring.
The sound is not recorded at
this time. The RECORD
button lamp flashes.
All tracks are in
playback monitoring
mode.
Press the foot switch at the
Punch Out point.
6. When you finish rehearsing, press the [STOP]
button.
If you are still unsatisfied, repeat steps 3-5.
Cancelling Rehearsal mode
1. While holding down the [STOP] button, press the
foot switch.
The display shows “
Rehearsal Off
” for 1 second, then the
flashing REHEARSAL LED turns off and cancels the
rehearsal mode.
To rehearse repeatedly, set the AUTO RTN START point
slightly before the Punch In point, and the AUTO RTN
END point slightly before the Punch Out point.
This will help you concentrate on your performance or
check the recording level easily (especially since Manual
Punch In/Out involves operating the foot switch
operation as well as the recorder). (See
“Rehearsing Auto Punch In/Out recording” for more
information.)
PUNCH
REHEARSAL
TAKE
AUTO
Model 8051 Foot switch
Manual Punch In/Out
This section explains how to perform Manual Punch In/Out using a foot switch (optional Model
8051). You do not need to specify the Punch In/Out points. Instead, you press the foot switch at
the Punch In/Out point. Manual Punch In/Out also offers rehearsal and actual takes. You can
repeat rehearsal until you are ready. As an example, replace a part of the recorded guitar solo on
track 3.
• Initialize the recorder.
• Select a desired Program for Punch In/Out.
• Check a sampling frequency of the recorder and external device.
Preparation
Check to see that the guitar is connected to the input
jack of the mixer, as required for [AUTO PUNCH IN/
OUT] mentioned earlier.
1. Connect an optional foot switch (Model 8051) to
the PUNCH IN/OUT jack on the rear panel.
Rehearsing Manual Punch In/Out
recording
In Rehearsal mode, the READY track enters input
monitoring mode between the Punch In and Out
points (the points at which you press the foot
switch), and the sound is not recorded. You can
practice the Punch In/Out operation repeatedly
before you proceed to actual recording.
1. Press the foot switch while holding down the
[STOP] button.
“
Rehearsal On
” will appear on the display or about 1
second, then rehearsal mode will appear and the
REHEARSAL LED (green) of the [
AUTO PUNCH
] key flashes.
2. Press the [RECORD TRACK] select key [3/11/19]
to set track 3 to READY.
3. Press the [PLAY] button to play back from a point
slightly before the Punch In point.
4. Play the guitar accompanying the playback of
tracks 1 to 8.
The recording level and monitor volume is adjusted on
the mixer in the same manner as done for [AUTO PUNCH
IN/OUT] described earlier.
5. Press the foot switch once at the desired Punch
In point, then press the foot switch again at the
desired Punch Out point.
The rehearsal mode will operate as shown in the figure.
Between the Punch In and Out points the current
performance of the guitar will be played as the guitar
monitor sound. The previous recording is heard in any
other case. The RECORD LED lights up when Punching
In and turn off when Punching Out. (the REHEARSAL
LED remains flashing)
2.Set the foot switch function to “Punch I/O” (punch
in/out function) by the SETUP mode “Setup of the
foot switch function” menu.
POWER
HOLD
RECORD
STOP
PLAY
REW
F FWD
ALL INPUT
ALL READY
LOCATE REC END
VARI PITCH
PUNCH
LOCATE
REHEARSAL
TAKE
RECALL
STORE
EXIT/NO
EXECUTE/YES
PGM SEL
NEXT
PREV
UNDO/REDO
PREVIEW
EDIT
SETUP
AUTO RTN
OUT
IN
AUTO PLAY
START
OUT
IN
END
17-24
ACCESS
9-16
1/9/17
2/10/18
3/11/19
4/12/20
5/13/21
6/14/22
7/15/23
8/16/24
FOOT SW
LOCATE ABS 0
CLIPBOARD PLAY
AUTO
TRACK SHIFT
SHIFT
DISP SEL
CHARACTER
TIME BASE SEL
P.EDIT
EJECT
ENVELOPE
CHASE
TC READY
TC GEN
M.UNDO
TRACK SHIFT
PREV TC
NEXT TC
RECORD TRACK
CLIPBOARD
AUTO PUNCH
AUTO RTN
LOCATE MEMORY
24bit
96kHz
OPTICAL
24TRACK DIGITAL RECORDER