Fostex D2424 - Manual (Page 43)

43
Model D2424 Reference Manual (Punch In/Out)
Manual Punch In/Out take
You can proceed to record if you are satisfied
with the recording level, foot switch timing, and
rehearsal.
You cannot record a second take during the Manual
Punch In/Out operation without stopping the recorder.
That is, the recorder will continue playing after you
finish recording a take, but you cannot record another
take by pressing the foot switch.
Press the foot switch at the
Punch In point.
Track 5
Track 6
Track 7
Track 8
Auto Punch In point
(Take In)
Track 1
Track 2
Track 3
Track 4
This part is changed.
Start point of
playback
Auto Punch Out point
(Take Out)
End point of
playback
All tracks are in
playback monitoring
mode.
Only track 3 in input
monitoring, and data will be
recorded. The RECORD
button lamp flashes.
All tracks are in
playback monitoring
mode.
Press the foot switch at the
Punch Out point.
1. Confirm that Rehearsal mode is cancelled, and
start playing the recorder from a point slightly
before the desired Punch In point.
2. Play the guitar, accompanying the playback of
tracks 1 to 8.
3. Press the foot switch at the desired Punch In
point. Press the foot switch again at the desired
Punch Out point.
The recorder enters recording mode at the Punch In
point, and cancels recording mode at the Punch Out
point.
4. Press the [STOP] button.
5. Play track 3 and check the result of Punch In/Out.
At “Take” of punch out, the punch-in recording track
will not immediately enter the repro monitor mode from
the input monitor mode enter the repro monitor mode
about two seconds after mute playback. This is a
functional feature of the recorder and not a malfunction.
You can use the [ PLAY ] button and the [ RECORD ]
button, instead of using the foot switch.
Follow the steps below.
This method also does not allow you to record
another take unless you stop the recorder first.
Procedure:
1.Press the [PLAY] button to start playback from
a point slightly before the Punch In point.
2.Press the [RECORD] button while holding down
the [PLAY] button at the desired Punch In point.
(Punch In recording starts.)
3.Press the [PLAY] button at the desired Punch
Out point. (Recording is punched out.)
• If you press only the [ RECORD ] button in both
steps 2 and 3, you can rehearse Punch In/Out.
Single Undo/Redo
You can single undo or redo Manual Punch In/
Out recording.
Press the [
UNDO/REDO ] key after recording is
complete to restore the conditions that existed
prior to the recording.
Press the [
UNDO/REDO ] key again to restore the
conditions that existed after the recording.
However, the procedures explained here is for
Single Undo/Redo and there are limitations as
written in the Notes below. If the current drive
was formatted with the multiple undo function
ON, Multiple Undo is also possible.
Refer to page “ 64 ” for details on the Multiple
Undo function.
Note-1 : This function only works when this
recorder is in the stop mode.
Note-2 : After finishing manual punch in/out,
please note that single Undo/Redo is not possible
if the following have been executed.
• If a new recording has been made.
• When a new editing job is executed (such as
Copy & Paste, Move & Paste, or Erase).
• When in the AUTO PUNCH ON mode, when
the AUTO PUNCH IN point is passed in the
PLAY (or RECORD) mode.
• If the power was switched off.
• If program select was executed.
• When multiple undo is executed.