Setting a preroll value, Setting a preroll value (“preroll time ?” menu), Setting a preroll time – Fostex D2424 User Manual
Page 112: Press the [execute/yes] key, Flashing
112
Model D2424 Reference Manual (Changing the Initial Settings
Locate point (stored in the memory key).
This point is actually located.
This point is located if the current position is before the locate point.
Preroll time (before the locate point) can be set between 00 and 10 seconds.
Flashing
Setting a preroll value (“Preroll Time ?” menu)
The recorder features the Preroll function that enables you to locate a position a few seconds prior to a
specified locate point. The “Setting a preroll value” menu allows you to set the preroll time (in seconds).
The Preroll function is convenient when you wish to monitor the audio data from a point slightly before the
locate point.
• Initial setting:
[00] second
• Setting range of preroll time:
[00]-[10] seconds in one second steps
* You can set the value for each Program individually.
* The settings can be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the recorder.
This point is located if the current position is after the locate point.
Setting a preroll time
1.While the recorder is stopped, press the [SETUP]
key to enter SETUP mode.
2.Turn the [JOG] dial to select “Preroll Time ?” (“?”
flashes.), then press the [EXECUTE/YES] key.
The current preroll time setting appears on the display.
Pressing the [
EXECUTE/YES
] key lights up the flashing
“
?
” character steadily; the current setting flashes.
The initial setting is “
00
” as shown below.
3.Turn the [JOG] dial to enter a desired preroll time
value.
You can set a value in one-second increments.
Rotating the [
JOG
] dial clockwise increases the value,
and rotating it counter-clockwise decreases the value.
4.Press the [EXECUTE/YES] key.
The display shows the value, then returns to the
indication that appeared in step 2.
To cancel the setting operation, or to restore the setting
obtained prior to the [EXECUTE/YES] key press, press
the [STOP] button or the [EXIT/NO] key. Each time
you press one of these keys, the recorder returns to
the previous hierarchy level of the menu, and finally
exits SETUP mode and displays the previous Time Base.
S
∞
42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
24
∞
42
OL
0
30
24
18
12
9
6
3
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
CLOCK
INT
S
∞
42
OL
0
30
24
18
12
9
6
3
kHz
24
FS
BIT
SETUP
24
∞
42
OL
0
30
24
18
12
9
6
3
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
CLOCK
INT