Great Plains DICKEY-john AI100 10-inch Virtual Terminal - Manual (Page 64)

OPERATOR’S MANUAL
10" Virtual Terminal
11001-1440-200701
62 / TASK CONTROLLER
Figure 57
Assigned Markers
MARKER OPERATION
Starting, stopping, and dropping markers can only occur while a Task is
running. Markers can be dropped or started at the Marker Operate screen.
To activate markers:
1. At the Task Controller Operate screen, press the Next Task button
until the marker setup screen appears.
2. Enable marker by pressing the appropriate Marker button or by
pressing the corresponding Marker Activation button. A yellow
highlight box around the corresponding Marker button indicates the
marker is enabled.
– Press the Assign Markers button to change or add markers.
– When enabled, a status bar at screen bottom will indicate marker
status based on Marker Type:
3. Press the Task Controller Operate button to return to the Operate
screen.
rock
grass
wet area
wet field
Assigned
Marker
Button
Marker Type Activation Status Indicator
Point Single button press Marker Dropped
Continuous Press to Start
Press to Stop Marker Started
Marker Stopped
Global Single button press Marker Dropped
Markers button
Marker Dropped button
Task Controller Operate button