Great Plains DICKEY-john AI100 10-inch Virtual Terminal - Manual (Page 30)

OPERATOR’S MANUAL
10" Virtual Terminal
11001-1440-200701
28 / TRACTOR ECU
THREE-POINT HITCH CONFIGURATION
The three-point hitch configuration screen allows hitch position to be set
and then monitored from the TECU Work screen. The hitch position can be
configured by enabling the hitch switch or the hitch position sensors on the
I/O Configuration screen.
The hitch switch can be set for Hi or Lo polarity. A hitch position sensor
should be calibrated for range of travel and “In Work” point.
Press the Hitch Configuration button to access the Hitch Configuration
screen.
Figure 21
Hitch Configuration Screen
HITCH SWITCH ACTIVE POLARITY
To configure the hitch switch using the Hi/Lo feature:
1. Place the physical hitch in the up or down position.
2. Press the Hitch Configuration button to access the Hitch
Configuration screen.
3. Press the Hitch Hi/Lo Button to match the physical position of the
hitch. Pressing Hitch Hi/Lo Button will toggle the Hi/Lo option.
4. Hitch position will appear correct on the TECU Work screen.
NOTE: The hitch switch must be
enabled on the I/O
Configuration screen to be
active on the Hitch
Configuration screen.
When using the hitch switch feature, the hitch position selection can be
disabled by unselecting on the I/O Configuration screen so it does not
appear on the TECU screen.
Verify that the hitch position is configured correctly on the TECU
screen to ensure proper operation occurs.
In Work
Point
Hitch
Position
Bargraph
Indicator
Upper Limit
Calibration
Point
Lower Limit
Calibration
Point
Current
Position
HI
LO
Three-Point Hitch Config button
Hitch Switch
Hitch Position