Great Plains DICKEY-john AI100 10-inch Virtual Terminal - Manual (Page 55)

OPERATOR’S MANUAL
10" Virtual Terminal
11001-1440-200701
TASK CONTROLLER / 53
RUNNING A TASK
A Confirm Task Setup screen will display with the selected Customer, Farm,
Field, and Crop selection () If there is more than one product, press the
Next button to scroll through all products until this screen appears.
– If a Task is created on an office PC, the Application Rate field
defaults to AUTO and cannot be changed.
– If a Task is created at the Virtual Terminal, the application rate
entered will display.
Task Status
The status of a task is identified on the Main screen as:
• None Selected - A task has not been selected
• Initial - Task is ready
• Running - Task is currently running
• Suspended - A task has been started and stopped but not saved to the
SD card
START A TASK
1. Press the Start Task button to begin the task.
Figure 48
Starting a Task (Product)
IMPORTANT: If the GPS signal is lost during a task, the rate will be
applied at the default rate created in the VRT application
map until the signal is re-established or the task is
stopped. There are NO alarms to indicate the GPS
signal has been lost or regained.
GPS status is indicated by the color of the GPS button:
Green = good signal
Red = lost signal
Yellow = no differential correction (still functional, less accurate)
brown, joe
south
south40
rock
IntelliAg - Ch1 Control
Ch1 Material Accumulator
0.0 lb
Ch1 Area Accumulator 0.00 ac
Select Operator
Next button
Start Task button
GPS button