Great Plains DICKEY-john AI100 10-inch Virtual Terminal - Manual (Page 31)

OPERATOR’S MANUAL
10" Virtual Terminal
11001-1440-200701
TRACTOR ECU / 29
HITCH POSITION USING UPPER AND LOWER
PARAMETERS
Hitch status based on a hitch position sensor can be configured by setting
upper and lower parameter points and setting the “In Work” position..
Calibration:
1. Press the Hitch Configuration button to access the Hitch
Configuration screen on the VT.
2. Move hitch to the highest position.
3. Press the Upper Limit Position Save button on the VT.
4. Move hitch to the lowest position.
5. Press the Lower Limit Position Save button on the VT.
6. The percentage (%) value will now reflect the position with the range of
movement of the hitch.
Setup:
Setting the “In Work” hitch position:
1. Move the hitch to the point that below the point is considered Work
mode and above the specified point is not in Work mode.
2. Select and enter the current value or press the Work Mode Position
Save button.
If known, the % value can be manually entered instead of performing the
above setup steps.
When using a hitch position sensor to monitor hitch position, the Hi/Lo Hitch
position feature can be disabled by unselecting the feature on the I/O
Configuration screen.
All necessary precautions must be taken to ensure user safety
around moving parts. Failure to practice all necessary caution may
result in serious injury or death.
Upper Limit Position Save
Lower Limit Position Save
Work Mode Position Save