Great Plains DICKEY-john AI100 10-inch Virtual Terminal - Manual (Page 41)

OPERATOR’S MANUAL
10" Virtual Terminal
11001-1440-200701
TASK CONTROLLER / 39
VARIABLE RATE OR SINGLE RATE TASK (PC)
A task created from a PC, whether single or variable rate, transfers data
from the SD card to the VT communicating the intended task data to the
control system, including products, rates, and field map indicating exact
product application in the field.
To Select a Task:
1. Ensure the SD card is inserted into the VT.
2. Press the Task Controller button.
3. To select a task loaded from the SD card, press either the Select Task
keys or press the Select Task selection box to scroll through and
select the desired task to run. All products identified for this task will
display under Allocated Products
.
4. To select an Operator, optional, press the selection box and use the
left or right arrows to scroll through selections.
– To create an Operator name, press the Maintenance button and
select the Operators tab. Refer to the Maintenance section for
further instruction.
IMPORTANT: Data, including rates, created from the PC cannot be
edited or adjusted from the Virtual Terminal.
Task summary totals will automatically display at screen bottom for any task
started previously.
NOTE: Verify that the SD card is
unlocked before trying to save
data.
Figure 31
Selecting a Task
5. Press the Next button to display the Select Bins (channel) screen.
6. A separate screen will appear for each product allocated to a channel.
Continue pressing the Next button until the the appropriate product
displays.
7. Press the input box to select the control channel to apply product.
When a checkmark is added to the channel input box, the selected
product name will appear.
corn
Initial
Select Task Optional Operator
Task Controller button