Great Plains DICKEY-john AI100 10-inch Virtual Terminal - Manual (Page 17)

OPERATOR’S MANUAL
10" Virtual Terminal
11001-1440-200701
VT DISPLAY / 15
SCREEN CALIBRATION
A screen calibration can be performed if the touch screen does not seem to
activate in the position pressed. Calibration is performed by touching the
cross marks on the screen.
To Perform Screen Calibration:
1. Press the Screen Calibration button.
2. On the next screen, touch anywhere on the display to begin calibration.
Press Escape key to cancel calibration.
3. Follow the on screen instructions, press and release the cross marks in
the upper left, upper right, lower right, lower left, and center mark
positions.
4. To save the calibration, push inside the box located in the center of the
screen.
AUXILIARY ASSIGNMENT
The Auxiliary Input/Function Assignment screen configures the system’s
Master Switch input to the TECU so that it will work with the IntelliAg control
function.
IMPORTANT: On initial powerup, a Master Switch Assignment alarm
activates requiring a switch assignment. If the Master
Switch is not configured, the Master Switch Assignment
alarm will activate at each power cycle until an auxiliary
assignment is made and will default to the Master Switch
button to activate auxiliary inputs.
An installed Master Switch located in the tractor cab is the preferred method
for auxiliary input; however, a Master Switch button will be assigned and
appear on the Work Screen if no assignment is made.
Figure 12
Aux input/Function Assignment Screen
Screen Calibration button
Auxiliary Input button