Socket Mobile Bluetooth iPAQ - Manual (Page 9)

CHAPTER 1: INTRODUCTION 9
The LED and beep behaviors below are for the Bluetooth CHS v2.
Status Indicator LED
LED LED Activity Meaning
1 blink per second Bluetooth radio is on, but not connected.
Bluetooth
Status
(Blue)
1 blink per 3 seconds Scanner connected to computer
Good Read
(Green)
On
Data successfully scanned and transmitted
to host device.
Blinking 20% battery capacity remaining
Battery
Status
(Red)
Off Off or Good Battery status
Status Indicator Beeps
Beep Pattern Meaning
2 beeps (low-high) Power on
2 beeps (high-low) Power off
1 beep Scanner connected to computer
2 beeps
(same tone)
Scanner disconnected from computer
2 long beeps
(same tone) with
Permanent Pairing
enabled
Scanner unsuccessfully tried 20 times to connect to the
device assigned as its Permanent Pair
1 beep with green
LED (optional
setting)
Data successfully scanned and sent to computer
Touch Screen Stylus
The Socket Bluetooth CHS features a stylus tip in the tail
of the Bluetooth CHS that you can use on Pocket PC and
other device touch screens.
WARNING: Do not use the stylus if damaged. A
damaged stylus may scratch the display screen of
your computer.
Note: The stylus does not work with tablets using Active Matrix displays.