Socket Mobile Bluetooth iPAQ - Manual (Page 84)

84
• Prefix/Suffix: Type characters you would like appended before or after
scanned data (100 character maximum). Besides special data items, only
printable ASCII characters can be used.
For the suffix, you can use these commands to move the cursor:
\n
carriage return
\d down
\i right
\l left
For BlackBerry smartphones, \t will not result in a tab.
• Beeper Frequency: Select the frequency of the beep that the Bluetooth
CHS emits to indicate good scans, power on/off, connection/
disconnection, etc.
• Good Scan Beep: Select to have the Bluetooth CHS beep to indicate that
data was successfully decoded and transmitted to the smartphone.
• Good Scan LED: Select to have the Bluetooth CHS LED turn green to
indicate that data was successfully decoded and transmitted to the
smartphone.
• Disable Auto Power off: Select to have the Bluetooth CHS stay on even
when there has been no connection to a device for 20 minutes.
3. After entering any settings, in the Options menu, click Save.
CS B
ONDING
This option eliminates the need to enter the passkey each time you connect.
1. In the SocketScan menu, click CS Bonding. In the dialog, click Bond with CS.
2. A dialog will direct you to enter the passkey the next time you connect to
suppress the passkey prompt in the future. Click OK.
V ERSION I NFORMATION
1. In the SocketScan menu, click About.
2. A screen will display the SocketScan version number. If the Bluetooth CHS
is connected, the Bluetooth CHS firmware version will also be reported.