Socket Mobile Bluetooth iPAQ User Manual
Page 72
72
4. Your device will begin searching for Bluetooth enabled devices in range.
After it finishes searching, select the Socket CHS from the list of
discovered devices and tap OK.
Note: The characters in brackets are the last 6 characters of the scanner’s
Bluetooth Device Address, which is labeled inside the battery compartment.
5. Your device will connect to the Bluetooth CHS. If a passkey is requested,
enter 1234.
6. When the devices connect, the Bluetooth CHS will beep once. The main
screen of SocketScan will report that the Bluetooth CHS is enabled, and
the Configure, Symbologies, and Test buttons will appear.
Note: If the PDA suspends, the Bluetooth CHS will automatically re-
connect once you turn on the PDA again.
Note: If the scanner is taken out of range, or if the Bluetooth
connection is otherwise lost, to resume operation you must enable
it again in SocketScan.