HP 5300 - Manual (Page 84)

Upgrading and Replacing Options
9-4 HP Smart Array 5300 Controller User Guide
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: j-ch9 upgrading and replacing options
Codename: SilverHammer Part Number: 135606-005 Last Saved On: 10/8/02 11:17 AM
Battery Pack
WARNING: There is a risk of explosion, fire, or personal injury if the battery
pack is replaced incorrectly or mistreated. To reduce the risk:
• Do not attempt to recharge the battery outside of the controller.
• Do not expose to water, or to temperatures higher than 60°C (140°F).
• Do not abuse, disassemble, crush, puncture, short external contacts, or
dispose of in fire or water.
• Replace only with the spare designated for this product.
Battery or array accelerator disposal should comply with local regulations.
Alternatively, return these parts by established parts return methods to HP,
your authorized HP Partners, or their agents for disposal.
To remove the old NiMH battery pack:
1. Push down on the battery pack clip, located near the lower corner of the array
accelerator.
Figure 9-4: Clip on battery pack
2. Rotate the battery pack away from the array accelerator board by an angle of
10 degrees.