HP 5300 User Manual
Page 159
Index
Index-6
HP Smart Array 5300 Controller User Guide
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: x-index
Codename: SilverHammer Part Number: 135606-005 Last Saved On: 10/8/02 11:29 AM
J
L
LEDs
blinking 7-8, E-3
identifying drives by, in ACU 7-8
interpreting drive status by E-2
lit on idle system H-4
limitations on
ACU use 7-2
controller port use 3-6
CPQONLIN use 7-2
drive movement E-9
hard drive capacity 7-1
hard drive types supported E-1
number of controllers per system H-1
number of hard drives per system H-1
number of logical drives allowed per
array 7-2
ORCA use 7-2
spare drive capacity 7-18
stripe size 7-13
linear memory 5-6
load balancing, defined D-7
logical drive capacity extension
description of E-11
procedure for 7-23
logical drives
compared to array D-3
creation of, with ACU 7-19
creation of, with CPQONLIN 7-33
creation of, with ORCA 7-3
defined D-2
enlarging (extending) E-11
failure of E-2, E-4
identifying, using ACU 7-8
maximum number of, per array 7-4,
maximum size of 7-14
multiple, creating 7-14
partitioning of 7-25
recovery of, options for E-4
LVD (Low Voltage Differential)
compatibility of, with SE H-2
distinction of, from Ultra3 SCSI H-2
support for 1-8
M
manual configuration of array
with ACU 7-16
with CPQONLIN 7-28
maximum
boot size, enabling 7-14
data preservation time 1-6
logical drive size 7-14
stripe size 7-13
maximum number of
controllers per system H-1
hard drives for RAID 5 D-10
hard drives for RAID ADG D-10
hard drives per system H-1
logical drives per array 7-4, 7-14
memory
allocation of, to cache, in ACU 7-10
allocation of, to cache, in
array accelerator 1-6
ECC SDRAM 1-6
linear 5-6
required amount of, for stripe size
change 7-25
migration
caution for 7-12
in ACU 7-25
in CPQONLIN 7-35
time required for 7-25, 7-35
minimum
cache memory required for stripe size
change 7-25
capacity of spare drive 7-18
number of hard drives for RAID D-10
mirroring of drives D-6