HP 5300 - Manual (Page 137)

POST Error Messages
G-6 HP Smart Array 5300 Controller User Guide
HP CONFIDENTIAL
Writer: Jennifer Hayward File Name: q-appg POST messages
Codename: SilverHammer Part Number: 135606-005 Last Saved On: 10/8/02 11:26 AM
Table G-1: POST Error Messages continued
Message Description Meaning and Recommended Action
1776 Slot x drive array – SCSI bus
termination error – internal and
external drives cannot both be
attached to the same SCSI port.
SCSI port (y): Check cables.
The internal and external connectors of the
specified SCSI port(s) are both attached to
drives. The SCSI bus is not properly
terminated when internal and external
drives are attached concurrently to the
same SCSI bus. The indicated SCSI bus is
disabled until this problem is resolved.
Turn off the server power and check the
cabling to the specified SCSI port.
1777 Slot x drive array – ProLiant drive
storage enclosure problem detected
(followed by one or more of the
following):
• SCSI port (y): Cooling fan
malfunction detected
• SCSI port (y): Overheated
condition detected
• SCSI port (y): Side-panel must be
closed to prevent overheating
• SCSI port (y): Redundant power
supply malfunction detected
• SCSI port (y): Wide SCSI transfer
failed
• SCSI port (y): Interrupt signal
inoperative
• Check SCSI cables.
Check the cooling fan operation by placing
your hand over the fan. Check the internal
plenum cooling fan in tower servers or
storage systems. If the fan is not operating,
check for obstructions and check all internal
connectors. Replace the unit side panel, if it
was removed.
When the ProLiant Storage System power
LED is amber instead of green, the
following conditions may be present:
• A fan failure
• A redundant power supply failure
• A thermal problem
If the message directs you to check SCSI
cables, check your cabling against the
diagrams in this user guide. If the routing is
correct, replace cables on the specified port
until the POST message is eliminated.
1778 Slot x drive array resuming Automatic
Data Recovery process. No action required. This message appears
whenever a controller reset or power cycle
occurs while Automatic Data Recovery is in
progress.
continued