Hughes SATELLITE HN9000 - Manual (Page 105)

Corrective action Explanation State name State code
Transient – No action is necessary. Modem has not been installed, and
installation parameters have not
been submitted. Waiting for Installation
Parameters 2
Transient – No action is necessary. Antenna pointing is in progress
(coarse or fine pointing). Occurs
during modem installation only. Coarse Pointing in
Progress 3
Transient – No action is necessary. Occurs during Auto modem
replacement only: Modem is
searching for beacon. Acquiring Beacon in
Boot 4
Transient – No action is necessary. Occurs during Auto modem
replacement only: Modem is
searching for point-to-point signal. Acquiring PTP SNR in
Boot 5
Installer should switch polarization. Modem is waiting for installer to
switch uplink polarization at the Waiting for Uplink
Polarization Change 6
radio assembly. Occurs during
installation only.
Transient – No action is necessary. Modem is in boot phase. Downlink
has been established; that is, Downlink Established in
Boot 7
beacon is being tracked and
transmission information packets
are being received.
Transient – No action is necessary. Modem is in boot phase and is
waiting for indirect and direct
management packets. Waiting for MIPs in Boot 8
Transient – No action is necessary. Modem is in boot phase and is
downloading commissioning
software. Downloading
Commissioning
Software 9
Installer must complete validation. Modem is waiting for antenna
pointing validation to complete.
Occurs during installation only. Waiting for Antenna
Pointing Complete 10
Installation – Commissioning phase
Transient – No action is necessary. Modem is starting up in
commissioning phase. Starting Up in
Commissioning 11
Transient – No action is necessary. Modem is in commissioning phase.
Downlink has been established; Downlink Established in
Commissioning 12
that is, beacon is being tracked and
transmission information packets
are being received.
Transient – No action is necessary. Modem is in commissioning phase
and is waiting for indirect and direct
management packets. Waiting for MIPs in
Commissioning 13
Transient – No action is necessary. Modem is in commissioning phase.
Probing is in progress. Occurs
during installation only. Probing in Progress 14
89
HN9000 Satellite Modem Installation Guide
1037576-0001 Revision E
Chapter 9 System Control Center