State codes, Figure 55: examples of state codes, Table 17: state codes – Hughes SATELLITE HN9000 User Manual
Page 104: Xplained in, Table 17, Table

Range of values
Typical values
Parameter
Not applicable
Enabled
Turbo Page
Not applicable
Disabled
SSL Acceleration
State codes
A state code is a number that indicates the operational state of the satellite modem. Some state
codes indicate an error condition. State codes are identified as State code followed by a number
from 1 – 35. They are displayed with an explanation in words, as shown in the following examples.
State codes appear on installation screens, on screens displayed during a hard reboot (when
power is removed and then restored), and on System Control Center pages.
Figure 55: Examples of state codes
on page 88 lists and explains all HN9000 state codes.
In the state code table, modem refers to the satellite modem.
Table 17: State codes
Corrective action
Explanation
State name
State code
Installation – Boot phase
Transient – No action is necessary.
Satellite modem is starting up in
boot phase.
Starting Up in Boot
1
HN9000 Satellite Modem Installation Guide
88
1037576-0001 Revision E
System Control Center
Chapter 9