You are unable to connect at 56 kbps, Network controller problems, Network controller is installed but not working – HP ProLiant Series ML100 User Manual
Page 72: Network controller has stopped working, Software problems, Operating system problems, Network c, Ontroller problems, You are n, Networ
3.
If this does not work, force a slower baud rate (14400 baud) with the AT command
.
AT&Q6N0S37=11
You are n
2.
Network c
Networ
Actio
1.
Check the network controller LEDs to see if any statuses indicate the source of the problem. For LED
3.
Be sure the network cable is working by replacing it with a known functional cable.
e. Refer to the operating system documentation for
lacing PCI Hot Plug devices, if applicable.
controller is enabled in the BIOS Setup Utility.
to date.
d to the controller and that the configuration settings are correct.
replace failed components as indicated.
Netwo
EDs to see if any statuses indicate the source of the problem. For LED
ller and that the driver file is not
placing it with a known functional cable.
the PCI slot is receiving power, if applicable.
u able to connect at 56 Kbps
Action:
1.
Find out the maximum baud rate at which the ISP connects, and change the settings to reflect this.
Reattempt to connect at a lower baud rate.
Be sure no line interference exists. Retry the connection by dialing the number several times. If
conditions remain poor, contact the telephone company to have the line tested.
ontroller problems
k controller is installed but not working
n:
information, refer to the network controller documentation.
2.
Be sure no loose connections (on page
4.
Be sure a software problem has not caused failur
guidelines on adding or rep
5.
Be sure the server and operating system support the controller. Refer to the server and operating
system documentation.
6.
Be sure the
7.
Check the PCI Hot Plug power LED to be sure the PCI slot is receiving power, if applicable.
8.
Be sure the server ROM is up to date.
9.
Be sure the controller drivers are up
10.
Be sure a valid IP address is assigne
11.
Run Insight Diagnostics and
rk controller has stopped working
Action:
1.
Check the network controller L
information, refer to the network controller documentation.
2.
Be sure the correct network driver is installed for the contro
corrupted. Reinstall the driver.
3.
Be sure no loose connections (on page
4.
Be sure the network cable is working by re
5.
Check the PCI Hot Plug power LED to be sure
6.
Be sure the network controller is not damaged.
7.
Run Insight Diagnostics and replace failed components as indicated.
Troubleshooting 72