HP ProLiant Series ML100 - Manual (Page 24)

5. Open the DIMM slot latches.
6. Install the DIMM.
7. ta
8. Install the access panel.
RBSU (" ROM-Based Setup
erver installation sheet on
Ins ll the air baffle.
9. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
If you are installing DIMMs in lock-step configuration, configure this mode in
Utility " on page 30 ).
For more information about LEDs and troubleshooting failed DIMMs, see the s
the HP website ( http://www.hp.com/go/bizsupport ).
Expansion board options
For server-specific expansion board installation instructions, refer to the installation
the server.
sheet that ships with
CAUTION: To prevent damage to the server or ex
remove all AC power cords before removing or installing the expansion boards.
pansion boards, power down the server and
To install the compon
1. we
2. Do one of the following:
o Unlock and remove the bezel (" Remove the tower bezel " on page 6 ).
o Extend the server from the rack.
3. Remove the access panel (on page 6 ).
ent:
r down the server Po (on page 6 ).
Hardware options installation 24