HP ProLiant Series ML100 - Manual (Page 16)

9. Close the processor socket retaining bracket and the processor retaining latch.
10. Install the hea
11. Insta
12. Do one of the following:
e tower bezel, as needed.
.
age 6 ).
SAS and SATA hard drive options
ports up to eight hard drives:
ith the embedded SATA controller
tsink. See the server installation sheet.
ll the access panel.
o Close or install th
o Slide the server back into the rack
13. Power up the server (on p
The HP ProLiant ML150 G6 Server sup
• SATA hard drives only w
• SAS or SATA hard drives with an optional SAS controller
For optimal performance, avoid mixing SAS and SATA hard drives.
To install a hard drive, see the server installation sheet on the HP website
(
http://www.hp.com/go/bizsupport ).
Hard drive LED cable option
An optional hard drive LED cable is required for hot-plug hard drive LED fu
storage controller.
To connect the hard drive LED cable:
1. Power down the server (on page 6 ).
2. Do one of the following:
o Unlock and remove the bezel (" Remove the tower bezel " on page
o Extend the server from the rack.
nctionality with an optional
6 ).
6 ). 3. Remove the access panel (on page
Hardware options installation 16