HP ProLiant Series ML100 - Manual (Page 31)

NOTE: If the boot drive is not empty or has been written to in the past, ORC
automatically configure the array. You must run ORCA to configure the array
A does not
settings.
AID function
oftware)
Drive configuration RAID function (smart
array controller)
R
(s
2 0 or 1 0 or 1
3 5 —
4 6 or 10 10
6 50 —
8 60 —
To ange any ORCA default settings and override the auto-configuration process, press the F8 ke
pted.
ch y when
prom
ch n process (such as the settings operating system
mpted. After the settings are
To ange any default settings in the auto-configuratio
and primary boot controller), execute RBSU by pressing the F10 key when pro
selected, exit RBSU and allow the server to reboot automatically.
For more information on RBSU, see the HP ROM-Based Setup Utility User Guide on the Documentation CD
or the HP website ( http://www.hp.com/support/smartstart/documentation ).
Boot
screen is visible for several
uring this time, you can do
the following:
BIOS e
the serial port to view POST error messages and run RBSU
OM port. The server that you are remotely configuring
does not require a keyboard and mouse.
For more information about BIOS Serial Console, see the BIOS Serial Console User Guide on the
options
Near the end of the boot process, the boot options screen is displayed. This
seconds before the system attempts to boot from a supported boot device. D
• Access RBSU by pressing the F10 key.
• Force a PXE Network boot by pressing the F12 key.
S rial Console
BIOS Serial Console allows you to configure
remotely through a serial connection to the server C
Documentation CD or the HP website ( http://www.hp.com/support/smartstart/documentation ).
Confi
g DIMMs " on page 23 ).
4. Select Chipset Configuration.
5. In Memory Mode, select Lockstep.
guring lockstep memory
To configure Lockstep memory:
1. Install the required DIMMs (" Installin
2. Access RBSU by pressing the F10 key during power-up when the prompt is displayed.
3. Select Advanced.
Software and configuration utilities 31