beautypg.com

Server blade to enclosure interface, Server blade to enclosure interconnect mapping – HP BL860C User Manual

Page 50

background image

Server Blade to Enclosure Interface

This section describes the interface between the server blade and the server blade enclosure. This
sections also shows the RJ-45 LAN interconnect ports on the rear of the server blade enclosure,
and how they correspond with the Network Interface Controller (NIC) LEDs on the front of the
server blade.

Port Locations on the Rear of the Server Blade Enclosure

LAN port mapping depends on the type of I/O card that is installed into the server blade.

Figure 27

shows some of the modules available for the c-Class enclosure.

NOTE:

This picture is used only to show the different modules, not where the modules should be

installed.

Figure 27 Interconnect Modules on the Rear of the Server Blade Enclosure

Server Blade to Enclosure Interconnect Mapping

Table 8 (page 50)

shows how the server blade slots interconnect with the slots on the c-Class

enclosure.

Table 8 Server Blade to Enclosure Interconnect Mapping

Server Blade to c-Class Enclosure Mapping

Enclosure

Interconnect Slots

Server Blade

NIC outputs or mezzanine slots

Slots 1 and 2

Ethernet NICs

Slots 3 and 4

Mezzanine Slot 1

50

Installing the Server Blade Into the Enclosure