HP BL860C - Manual (Page 168)

Example 22 pdt Command
Shell> pdt
PDT Information
Last Clear time: PDT has not been cleared
Number of total entries in PDT: 50
Number of used entries in PDT: 0
Number of free entries in PDT: 50
Number of single-bit entries in PDT: 0
Number of multi-bit entries in PDT: 0
Address of first multi-bit error: x0000000000000000
Example 23 pdt clear Command
Shell> pdt clear
Are you sure you want to clear the PDT? [y/N] y
Shell>
Shell> pdt
PDT Information
Last Clear time: 10/21/01 5:00p
Number of total entries in PDT: 50
Number of used entries in PDT: 0
Number of free entries in PDT: 50
Number of single-bit entries in PDT: 0
Number of multi-bit entries in PDT: 0
Address of first multi-bit error: 0x0000000000000000
sysmode
Display or modify the system mode.
Syntax
sysmode
Parameters
sets system mode to normal
sets system mode to admin
sets system mode to service
Operation
If specified alone, sysmode displays the system mode. If a mode is specified as a parameter, then
the system mode is changed. This new mode takes effect immediately. The system mode is retained
on successive boots. Interaction with
sysmode in a variety of scenarios is outlined below.
168 Utilities