Replacing the front display assembly, Removing and replacing the server battery, Figure 49 – HP BL860C User Manual
Page 121
Figure 49 Removing the Front Display Assembly Housing Screws
4.
Remove the front display assembly from the front of the server blade by pulling it straight off
the front of the server.
See
Figure 50 Removing the Front Display Assembly from the Front of the Server Blade
Replacing the Front Display Assembly
To install the new front display assembly into the server blade after a front display board failure:
1.
Slide the front display assembly onto the front of the server blade chassis.
Make sure the connector on the front display assembly is lined up with the plug on the system
board.
2.
Attach the front display assembly to the front of the server blade with the Torx T-15 screwdriver.
3.
Install the access panel.
See
“Replacing the Server Blade Access Panel” (page 112)
4.
Place the server blade back into the enclosure and power it on.
See
“Replacing the Server Blade in the Enclosure” (page 111)
.
Removing and Replacing the Server Battery
The following procedures describe how to remove and replace the server battery on the system
board of the server blade.
Removing and Replacing the Server Battery
121